Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
IN S TA LLA TION M A N U A L
9. Appliance-specific information
The appliance-specific instructions as described in this section prevail over the instructions in the other sections! If
!CAUTION
in doubt follow the instructions in section 9 or contact your supplier.
9.1 Placing the appliance
In order to promote a stable set-up, the Instyle Corner appliances are provided with adjustable feet (see Annex 2,
fig. 3). These feet can be adjusted by means of the supplied socket screwdriver.
Ø
Remove the vermiculite from the bottom.
Ø
Turn the socket screwdriver to the right in order to adjust the fire upwards, and to the left to adjust the fire
downwards.
9.2 Outside air connection and air slide valve
9.2.1 Outside air connection
The fire is made with an outside air connection. This outside air connection is supplied separately.
Assembly always takes place at the bottom of the appliance.
When mounting the outside air connection, please proceed as follows (see Annex 2, fig. 4):
Ø
Loosen the 5 bolts that are pre-mounted on the outside air connection.
Ø
Bring the outside air connection against the plate on the bottom of the appliance.
Ø
Then re-tighten the 5 bolts.
Ø
Connect the flexible hose (Ø 80 mm) to the round pipe opening of the outside air connection. The flexible hose
can be fed from the back or the bottom.
9.2.2 Air slide valve
When installing and maintaining the appliance, please check the operation of the air slide valve
(see Annex 2, fig. 5). It is possible that steel grit entered the air slide valve during transport. If the air slide valve
does not move smoothly it must be cleaned. For this purpose, the air slide valve must be disassembled.
The suspended air slide valve is spring-mounted using a bolt and a spring, which are located below the cover
plate.
When mounting the air slide valve, please proceed as follows (see Annex 2, fig. 5):
Ø
Remove the vermiculite plates from the bottom (see section 9.3.1).
Ø
Unscrew the cover plate's 6 Allen screws from the bottom.
Ø
Remove the cover plate.
Ø
Only in case of an outside air connection, unscrew the 2 screws from the front strip and remove it.
Ø
Remove the front strip or the outside air connection plus front strip.
Ø
Unscrew the Allen screw with spring.
Ø
Remove the air slide valve by bringing it towards you.
Ø
Check the air slide valve and clean it if necessary.
In order to replace the air slide valve, proceed as described for removal, only in reverse order.
37
Advertenties
Hoofdstukken
Inhoudsopgave
