Safety Instructions; General Information; Intended Use - Becker Centronic SensorControl SC811 Montage- En Gebruiksaanwijzing

Verberg thumbnails Zie ook voor Centronic SensorControl SC811:

Gebruiksaanwijzing (36 pagina's)

Montage- en gebruiksaanwijzing (36 pagina's)

pagina van 44

/ 44
Inhoud
Inhoudsopgave
Bladwijzers

Inhoudsopgave

Advertenties

Beschikbare talen

General information

• Please keep the instruction manual safe!

• Only use unmodified original parts from the control unit manufacturer.

• Keep children away from control units.

• Observe all pertinent country-specific regulations.

Caution

•

Risk of injury due to electric shock.

•

Connections to the 230 V mains must always be per-

formed by an authorised specialist.

•

Disconnect the connecting cable from the power prior to

installation.

•

Keep people out of the system's range of travel.

•

If the system is controlled by one or more transmitters,

the system's range of travel must always be visible during

operation.

•

When connecting the control cables (protected extra-low

voltages), only use cables with sufficient electrical

strength.

•

Observe the specifications for the sun protection system.

The sensor described in this instruction manual must only be used for operat-

ing Centronic-compatible radio drives and radio control units. The sensor is in-

tended solely for the operation of sun protection systems. Use for other pur-

poses or for purposes beyond the above constitutes improper use.

• Please note that radio-controlled systems may not be used in areas with

a high risk of interference (e.g. hospitals, airports).

• The remote control is intended solely for use with equipment and sys-

tems in which malfunctions in the transmitter or receiver would not pose

any risk to persons, animals or property, or which contain safety devices

to eliminate such risks.

• The operator is not protected from interference from other telecommu-

nications systems and terminal equipment (e.g. even from radio-con-

trolled systems which are properly operated in the same frequency

range).

• Only connect radio receivers to devices and systems approved by the

manufacturer.

14 - en