Advertenties
Beschikbare talen
Beschikbare talen
EN
I S O 2 3 0 - 1 6 C a n d I S O 2 3 0 - 2 5 C
Putting into operation
Once the isometer has been connected and the connections have
been checked, the system can be activated. The isometer will
perform a self-test (see the "Automatic self-test" section). Next,
the system is on standby and can, therefore, be used.
O P E R A T I O N A L
Self-test
Automatic self-test
The isometer will automatically run through a connection test and
a self-test every time the current source is switched on. "TES" will
be displayed on the display and all LEDs will light up. After 6 to 12
seconds, the isometer will start up and only the ON LED will be lit
if no errors have been detected. This self-test will, moreover, be
performed every 24 hours.
13
Advertenties
