Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fig.1
1: maximum diameter
2: maximum height
Pay attention when put the cylinder to the cylinder hole, ensure
the hose connect to the cylinder not touch the hot surface.
Keep the cylinder stay in place during operation. Never put spare
cylinder in the same cylinder enclosure. Never block the way of
shut off the cylinder valve.
Warning: Shut off the gas cylinder when you smell gas.
Disconnect LP Gas cylinder
Before disconnecting make sure the LP gas tank valve in "CLOSED"
Disconnect gas line from LP gas cylinder by turning knob counterclockwise until it is loose.
After connecting to gas cylinder, a leak testing is necessary.
DANGER: When changing the gas container, care must be taken to keep away from any source
of ignition.
Leak Testing (To be performed in a well-ventilated area)
• Confirm all appliance control knobs are in the off position.
• Open the gas control valve on gas cylinder.
• Check for leaks by brushing soap solution over all gas system joints, including all valve
connections, hose connections and regulator connections.
!
NEVER USE AN OPEN FLAME to test for leaks at anytime.
• If bubbles form over any of the joints, there is a leak. Turn off the gas supply and retighten that
joint. Repeat the test. If bubbles form again, stop trying; contact your local dealer for assistance.
Leak test annually, and whenever the gas cylinder is removed or replaced.
6. Operating instructions
Warnings
* Before proceeding, make certain that you have assembled the appliance according to
instructions.
* Never use your fireplace in a building, garage, shed, breezeway, or any other enclosed
area.
* Never obstruct the flow of ventilation air around your gas grill housing.
Before lighting
Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear
or abrasion, it must be replaced prior to use. Check leakage before use. Do not use the grill if
the odor of gas is present.
Lighting instructions:
1. Ensure that unit valve dial is in the "off"position by pushing and
turning clockwise until the dial stops.
2. Securely attach regulator(large end of hose) to your cylinder.
3. Extend hose to full length and ensure that the propane tank
is as far as safely possible from the Fire Bowl.
4. Slowly turn cylinder valve to"HIGH"position,push the IGNITE
to light the fire pit.
5. After fire pit lights, release control knob. Push in and turn
the control knob to the "HIGH", then release control knob.
If you want a lower temperature, push in the control knob and
turn counterclockwise to the "LOW".
IF THE BURNER DOES NOT LIGHT WITHIN 30 SECONDS, TURN THE VALVE OFF AND WAIT 5 MINUTES
FOR ANY GAS TO DISSIPATE BEFORE REPEATING THE PROCEDURE.
TO SHUT DOWN THE BURNER, TURN THE BURNER CONTROL KNOB CLOCKWISE TO THE OFF
POSITION. THEN TURN THE GAS OFF AT THE SOURCE.
- 22 -
LP gas cylinder of 10 KG. The maximum d
330mm and 500 mm as shown in (Fig.1).
Fig.1
1: maximum diameter
2: maximum height
Pay attention when put the cylinder to the cylin
the hot surface. Keep the cylinder stay in place
cylinder enclosure. Never block the way of shu
Warning: Shut off the gas cylinder when you s
Disconnect LP Gas cylinder
Before disconnecting make sure the LP gas ta
Disconnect gas line from LP gas cylinder by tu
After connecting to gas cylinder, a leak testing
Danger:
When changing the gas container, ca
Leak Testing
(To be performed in a well-vent
Confirm all appliance control knobs are in
Open the gas control valve on gas cylinde
Check for leaks by brushing soap solution
hose connections and regulator connectio
NEVER USE AN OPEN FLAME to test fo
If bubbles form over any of the joints, there
Repeat the test. If bubbles form again, stop try
annually, and whenever the gas cylinder is rem
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
