Inhoudsopgave
Advertenties
1.3. Symbolen gebruikt op de behuizing
De volgende symbolen worden gebruikt op de behuizing van de PV-lader:
Symbo
Naam
ol
Waarschuwing gevaar voor
elektrische schokken
Waarschuwing heet
oppervlak
Lees de handleiding
Beschermingswaarde
tegen binnendringen
Aardingssymbool
1.4. FCC and Industry Canada compliance
This device complies with part 15 of the FCC Rules and to RSS of Industry Canada. Operation is subject to the following two
conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation
of this equipment in a residential area may cause radio interference in which case the user will be required to correct the
interference at his own expense.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de Classe A est conforme à la norme Canadienne ICES-003.
This device contains a transmitter with FCC ID: SH6MDBT42Q.
This device contains a transmitter with IC: 8017A-MDBT42Q.
To comply with FCC and Industry Canada RF radiation exposure limits for general population, the antenna(s) used for this
transmitter must be installed such that a minimum separation distance of 20cm is maintained between the radiator (antenna) and
all persons at all times and must not be co-located or operating in conjunction with any other antenna or transmitter.
Pagina 2
MPPT zonnelader handleiding
Betekenis
Raak de elektrische aansluitingen niet aan, er bestaat gevaar voor elektrische
schokken.
Raak het oppervlak van het apparaat niet aan, terwijl het in bedrijf is wordt het
heet.
Lees de producthandleiding vóór installatie en gebruik.
IP43 - De elektronische componenten zijn beschermd tegen gereedschap en
kleine draden groter dan 1 millimeter en beschermd tegen waternevel onder
een hoek van minder dan 60 graden ten opzichte van de verticaal.
Geeft de plaats aan van de chassis aardverbinding
Veiligheidsvoorzorgsmaatregelen
Advertenties
Inhoudsopgave
