Inhoudsopgave
Advertenties
12
q
Device 21 error:
LED
No communication
Device 22 error:
LED
No communication
w
Device 21 error:
LED
Blocked
Device 22 error:
LED
Blocked
e
LOW-HIGH Vdc supply
LED
LNB OK
r
Vdc supply OK
LED
LNB OPEN
Vdc supply OK
LED
LNB SHORT
24
En
Error Display signal
In case of anomalous functioning, the system
shows the message with error type.
To reset the system remove and replace the Con-
trol Unit power supply (+12 VDC).
If the message remains, refer to a service centre.
Communicatiestoringen
The Control Unit and the rotation unit do not com-
municate anymore.
• Check the connection between the Control Unit
CU and the external unit.
Check that the control cable is correctly in-
serted into the control unit and that the related
connector is fully pushed into its seat.
• Remove and replace the Control Unit power
supply (+12 VDC).
If the message remains, refer to a service centre.
Motor error
A malfunction occurred in the system so that it
created an anomalous power absorption.
• Check that the parabolic antenna has not hit an
obstacle (e.g. a branch, snow or ice) and that it
can move freely. Check that the power supply
voltage is correct.
• Remove and replace the Control Unit power
supply (+12 VDC).
If the message remains, refer to a service centre.
Advertenties
Inhoudsopgave
