Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. ELECTRICAL CONNECTIONS
4.1 Electrical panel
• Insert the cables with the pre-wired terminal boards in the housing (fig. 11) and connect them to the boards (as shown in
chap. 5). Fit the cables in the conduit and connect the connectors on the motor (fig.12).
Cabling connection on the board must be done with main power cut off, for at least 30 sec.
4.2 Electrical panel/motor/safety device connections
• Figure 13 shows the layout of the cables supplied and their position in the door; each cable is identified by a special code
on an adhesive label.
4.3 Safety photocells
• Make the connections in the control panel as shown in the diagrams in chap. 5.
PH ≤ 3500 = 9523
PH > 3500 = 9126
Correctly size the line conductor cross-section by referring to the indicated absorption and taking the length and
installation of the cables into account.
11
230 V
Inverter
8132
0 1
8265A
- 31 -
T
Tx
Rx
EN
12
13
0 6 1
8265B
0DT869 01-12-2021
Advertenties
Hoofdstukken
Inhoudsopgave
