Scan sensitivity setting – FM
Your radio includes a local/distant option for the auto-scan function. By setting the radio to the 'local'
scan option, weaker signals from more distant transmitters can be ignored by the radio, making stronger
signals easier to find.
1. Press the Power On/Off button to switch on your radio.
2. If needed, press and release the Mode button until the FM band is selected.
3. Press and hold the Info/Menu button to access FM menu. Rotate the Tuning control knob until "FM
Scan Zone" shows on the display. Press and release the Tuning control knob to enter the scan
sensitivity adjustment mode. The current setting will be marked with an asterisk.
4. Rotate the Tuning control knob to switch between 'Local' (Strong stations only) and 'Distant' (All stations)
options on the lower line of the display. The Distant option will allow the radio to find weaker signals
when scanning.
5. Press and release the Tuning control knob to confirm your selection. The setting is stored in the radio
and remains in force until changed or until a System Reset.
Preset stations in DAB and FM modes
There are 5 memory presets for each DAB/FM wavebands.
1. Press the Power On/Off button to switch on your radio.
2. Tune to the required station as previously described.
3. Press and hold the required Preset button until the display shows e.g. Preset 2 stored. The station will
be stored under the chosen Preset button. The corresponding preset number e.g."P2" will show on
the display. Repeat this procedure for the remaining presets.
4. Station stored in the memories may be over written by following the above procedure.
Recall a preset in DAB and FM modes
1. Press the Power On/Off button to turn on the radio.
2. Press the Source button to select the required waveband.
3. Momentarily press the required Preset button, the preset number and station will appear in the display.
Note: The display will show "Preset Empty" if no station has been stored to that preset.
GB
10