PLEASE READ INSTRUCTIONS BEFORE USING THIS APPLIANCE.
KEEP THE INSTRUCTIONS SAVE.
INDOOR USE ONLY.
INTRODUCTION, REQUIREMENTS AND SAFETY
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock and injury.
Plug warmer into a grounded outlet with correct voltage and sufficient power capacity. Refer to the product
label (serial plate) on the warmer for voltage and wattage requirements.
Clean machine thoroughly before and after each use following the cleaning instructions provided below.
WARNING! All power must be disconnected at power source before any service procedure is performed.
WARNING! This electrical appliance contains a heating function surfaces, also different than the functional
surfaces, can develop high temperatures. Since temperatures are differently perceived by different persons,
this equipment shall be used with CAUTION. The equipment shall be touch only at intended handles and
gripping surfaces, and use heat protection like gloves or similar. Surfaces other than intended gripping
surfaces shall get sufficiently time to the cool down before getting touched.
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible
materials, such as drapes and other furnishings, away from appliance.
Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is
left unattended.
Always unplug appliance when not in use and before cleaning, adjusting or maintaining this machine. To
disconnect appliance, turn switch off and remove plug from power source.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, has been
dropped or damaged. Return appliance to an authorized service facility for examination, electrical or
mechanical adjustment or repair.
Do not use outdoors. This appliance is not intended for wet or moist locations. Never locate appliance where
it may fall into water.
Connect to properly grounded outlets only. Avoid the use of extension cords. Do not run cord under
carpeting, runners or the like. Arrange cord away from traffic area and where it will not create a tripping
hazard.
To prevent a possible fire, it is recommended that the unit is placed on a non-combustible surface.
This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are
used or stored.
PREPARATION
1.
Set the unit on a flat surface.
2.
Insert the Supporter Arm into the Stand.
3.
Adjust the Supporter to appropriate height and insert the screw to fix the height.
4.
Install bulbs with the appropriate wattage rating as indicated on the warmer.
www.combisteel.com
3