Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cleaning, Care & Maintenance
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
An agent or qualified technician must carry out repairs if require.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
We recommend that your agent or qualified technician clean the condenser
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to your retailer.
Fault
The appliance is
The unit is not switched on
not working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance
Too much ice on the evaporator Defrost the appliance
turns on, but the
Condenser blocked with dust
temperature is
Doors are not shut properly
too high/low
Appliance is located near a
heat source or air flow to the
condenser is being
interrupted
Ambient temperature is too high Increase ventilation or move appliance to a cooler
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
Probable Cause
www.combisteel.com
Solution
Check the unit is plugged in correctly and switched on
Call agent or qualified Technician
Replace the fuse
Check power supply
Call your agent or qualified Technician
Clean the condenser
Check doors are shut and seals are not damaged
Move the refrigerator to a more suitable location
position
Remove any excessive hot foodstuffs or blockages to the
fan
Reduce the amount of food stored in the appliance
8
Advertenties
Inhoudsopgave
Probleemoplossen
