P U T T I N G I N T O S E R V I C E
Commissioning of the Infrared Stand Panel from ETHERMA
1.
Before commissioning, please check the power connection
cable on the radiator and the surface. These must not be
damaged.
2.
Position the infrared heater at the desired installation lo-
cation.
3.
Check that the unit is firmly in place.
4.
Now you can plug in the appliance and put it into operation.
You can use the remote control to set your desired comfort
temperature..
IMPORTANT: The LAVA® STAND infrared heater
must be checked for its stable position before
starting up.
IMPORTANT: If the mains connection cable of the
appliance is damaged it must be replaced by a
skilled, qualified person without delay.
14
Commissioning remote control
1.
Insert two new AAA batteries into the remote control. Pair
the remote control and the receiver the first time.
2.
Prepare the infrared stand panel. Set the "Remote Switch"
to "OFF" and the main switch to "ON".
3.
Switch on the remote control and press the °C/°F and
MODE buttons on the remote control simultaneously to
pair the remote control and the receiver until you hear a
long beep.
Note: The remote control can be paired with several infrared
panels at the same time. Therefore, before pairing, switch off
the heaters that are not to be paired. If the switch on the infrared
stand panel is set to ON, the remote control is deactivated.
Remote control switch
ON= Remote control inactive
Main switch