Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not work.
Heavy
build-up
possibly also on the door seal.
Unusual noises.
The compressor does not start
immediately after changing the
temperature setting.
Water on the floor or storage
shelves.
Changing the light bulb
Warning!
If the LED light bulb is damaged, DO NOT CHANG IT BY THE USER!
Changing the
LED
malfunctioning.
it must be replaced by a qualified persons in order to avoid a hazard. Contact your local Service
Force Center for help.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the
circuit breaker.
LED light bulb data:
To switch off the appliance, set the temperature regulator to position
KGC 250/70-1 A+++
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the last
24 hours.
The appliance is near a heat source.
Light bulb is defective.
of
frost,
Door seal is not air-tight(possibly
after reversing the door).
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
This is normal, no error has occurred.
Water drain hole is blocked.
light bulb carry out by inexperienced persons may cause injury or serious
220-240 V,
Version E1.0 EN 01/2014
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator
to a warmer setting temporarily.
Please look in the "initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the "installation
location" section.
Please look in the "changing the
Light Bulb "section.
Carefully
warm
the
sections of the door seal with a
hair dryer(on a cool setting). At
the
same
time
shape
warmed door seal by hand such
that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
See the "cleaning and care"
section.
0 .
leaking
the
Page 13 of 15
Advertenties
Inhoudsopgave
