Download Inhoudsopgave Inhoud Print deze pagina

Electrical Connection; Installing The Appliance Under A Worktop - Inventum VVW6040AB Gebruikershandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Note: Do not use a drain hose that is longer than 4 meter. As a result, dishes can remain dirty. The
manufacturer will not accept responsibility.
Keep the mark on the appliance in mind. If the appliance is marked '25', it means that the water temperature of
the cold water can be maximum 25°C.

ELECTRICAL CONNECTION

Warning: Make sure that the mains plug of the appliance is connected to a grounded mains socket.
The manufacturer is not responsible for damage resulting from using the appliance with a mains
socket that is not grounded. Only an authorized electrician can install a grounded mains socket, if not
available.
Make sure that the voltage and the frequency values for the current correspond to the values of the rating plate.
Warning: The electrical system in your home must be supplied with a 10-16 Amp fuse. The appliance
is designed for connecting to 220-240 V ~50Hz.
Do not connect the appliance during placement.
Caution: Use the provided mains plug.
The mains cable of the appliance must only be replaced by an authorized service or an authorized electrician.
Failure to do so can lead to accidents.
Caution: For safety reasons, make sure that you disconnect the mains plug when a program has
finished. Do not disconnect the mains plug when your hands are wet. This can result in electric
shock.
Caution: Always pull the mains plug when you disconnect the appliance. Do not pull the mains cable.
Warning: The appliance is set to operate at 220-240V. Connect a 110/220V and 3000W transformer
between the electrical connection if the mains supply is 110V.

INSTALLING THE APPLIANCE UNDER A WORKTOP

Warning:
The worktop must be stable.
Caution:
Make sure that the wiring and plumbing is suitable for installing the appliance under a worktop.
Caution:
Make sure that there is enough space under the worktop to install the appliance.
Preparing the appliance
In order to install the appliance under a worktop, the top panel must be removed.
1. Remove the screws at the rear of the top panel.
2. Push the panel rearwards for approximately 1 cm.
3. Lift the panel to remove it.
(Figure 3)
English
45

Advertenties

Inhoudsopgave
loading

Inhoudsopgave