Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• For a single phase or two phase connection
use the following (or higher) mains cable
type: H05V2V2-F T min 90°C.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Building In
min. 100 mm
min. 55 mm
30 mm
Technical information
Cooking zones specification
Cooking zone
Left front
Left rear
Right front
18
min. 650 mm
550 mm
A
B
Nominal Power (Max heat setting)
[W]
1500
1000
1500
A) supplied seal
B) supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.
Possibilities for insertion
The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
Kitchen unit with door
A
60 mm
B
A) Removable panel
B) Space for connections
Kitchen unit with oven
The electrical connection of the hob and the
oven must be installed separately for safety
reasons and to let easy remove oven from the
unit.
Cooking zone diameter [mm]
180
145
145
30 mm
min 20 mm
(max 150 mm)
www.zanussi.com
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
