When a button is pressed - no
reaction of the machine.
Programme inactive, Bac plein
(Water Reservoir) light up.
Drying cycle ends shortly after
programme starts. Anticrease/
End light up.
Drying cycle lasts an unusually
long time. Note: After up to 5
hours the drying cycle ends
automatically (see 'End of dry-
ing cycle').
Discoloration
Machine settings
Setting
Alarme (Buzzer) permanent
off
www.zanussi.com
Ventilation slots in base area cov-
ered up.
Residue on inside surface of drum or
drum ribs.
Conductance of water at installation
site differs from standard setting of
machine.
Drying protection. After the start of
the programme, the option can no
longer be set.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for selec-
ted programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature.
Temporary switching off of the com-
pressor to avoid overload.
Colour fastness of textiles.
1. Turn the programme selector to any programme.
2. Press simultaneously the Délicat (Delicate) and Anti-Froissage
(Long Anticrease) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off.
Uncover ventilation slots in base
area.
Clean inside surface of drum and
drum ribs.
Re-programme standard setting for
degree of drying (see 'Programming
options' chapter).
Turn the programme knob to O off.
Set the programme again.
Empty condensate tank, then start
programme with Marche/Arrêt (Start/
Pause) button.
Select time programme or higher
drying level (e.g. Très sec (Extra Dry)
instead of Prêt à ranger (Cupboard
Dry)
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault
with the appliance. If possible, lower
the room temperature.
Check colour fastness of textiles.
Only treat textiles together if they are
a similar colour.
Implementation
13