Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
HOB
Installation
• This appliance should only be connected by a
registered installer.
• Prior to installation, ensure that the local distribution
conditions (voltage, frequency, nature of the gas and
gas pressure) and the adjustment of the appliance are
compatible.
• The voltage, frequency, power, type of gas and the
country for which the appliance has been designed are
shown on the appliance rating plate.
• The electrical connection must comply with national and
local regulations.
• The wall plug socket and plug should always be
accessible.
• If a stationary appliance is not fitted with a supply cord
and a plug, or with other means for disconnection from
the supply mains having a contact separation in all
poles that provide full disconnection under overvoltage
category III conditions, the means for disconnection
must be incorporated in the fixed wiring in accordance
with the wiring rules. Using an omnipolar switch with a
contact separation of at least 3 mm fitted in the supply
cable will fulfil this requirement.
• For connecting, use an approved cable with the correct
cable diameters appropriate for the connection. The
cable casing should be made of rubber (preferably of
the H05V2V2 or H07V2V2 type).
• The connection cable must hang freely and should not
be fed through a drawer.
• The gas connection must comply with national and local
regulations.
• This appliance is not connected to a combustion
products evacuation device. It shall be installed and
connected in accordance with current installation
regulations. Particular attention shall be given to the
relevant requirements regarding ventilation.
EN 7
Advertenties
Inhoudsopgave
