Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
19
First loosen the M10X102mm bolt assembled, the M10X102mm bolt isn't used in this
system.
1.
Attach rear struts (29,30) to base support frame (24) using two M8X55mm but-
ton bolts (B1) and two M8 washers (D2), and two M8 locknuts (C2).
Do not tighten the locknuts.
2.
Remove the M10X80mm bolts (A13) assembied on step 16.
3.
Then, attach four struts (31,32) to the four base assembly (22) using two
M10X80mm bolts (A13), four M10 washers (D3) and two M10 locknuts (C3).
Do not tighten the locknuts.
4.
Attach struts (29,30,31 and32) to the bottom pole (3) using an M10X120mm
bolt (A27), two M10 washers (D3) and an M10 locknut (C3).
Finally, tighten all of the bolts in this step.
20
1.
Make sure all the bolts are tightened in the system.
2.
Place the other sandbags (34-2). Pull the zipper well.
21
1.
Use the rear handle for adjusting the rim height.
2.
Use the front handle for moving the system.
3.
In case of uneven ground, you can adjust the adjustment foot.
Note: Check whether the entire system is tight. If the system is loose, please
correct and tighten all the nuts.
22
Instructions:
A. To adjust the rim height, follow the steps below:
1.
Turn the knob to free the adjustment knob (5). See picture (1);
2.
Then grasp the slider handle and rear handle (14) to pull the frame up or down
to a hole preferred by you and click the knob back. See picture(3);
3.
Tighten the adjustment knob (5). See picture (2).
B. In case of uneven ground, you can adjust the adjustment foot. See picture(4).
C. To move the basketball system, follow steps below to adjust:
1.
Loosen the two M12 nuts, turn the two adjustment feet back, which should lower
the wheel carriage assembly. See picture (5).
2.
Move to the right place. Turn the two feet higher than the front base assembly
and adjust their length to make sure the system is even with the ground. See
picture (6).
3.
Tighten M12 nut securely.
14
Galaxy
Basketball Systems
Advertenties
Inhoudsopgave
