Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installing the sealing
The diagrams on pages 28 and 29 indicate when you
need to place a sealing. If this is the case, the seal must
be placed on the inside of the combustion chamber (see
illustration). The diameter of the seal must be 50 mm.
Completing the installation
The concentric system is now fitted and the fireplace
is installed. To complete the installation, the following
must be carried out:
Opening the door
The Solea gas fireplace must be lighted only when the
door is closed. The door is locked for safety reasons. Page
20 gives a description how to open the door. When the
door is opened you can place the ceramic lumber set in
the hearth and put the batteries in the receiver. The Solea
can be used with both natural gas and propane.
Arranging the log set for natural gas
Arranging the log set for propane gas.
30
30
Placing the ceramic logs
NATURAL GAS
Caution: wrong
Place the 8 ceramic logs as shown in the illustration
placement of the
below. The log set must be placed exactly as in the
seal may cause
example. Make sure the door is closed before igniting
malfunction of the
the hearth.
appliance.
Do not add or change anything to the ceramic logs.
Make sure the pilot light is uncovered at all times, and
that it can reach the main burner freely.
PROPANE GAS
Place the 7 ceramic logs as shown in the illustration. The
log set must be placed exactly as in the example. Make
sure the door is closed before igniting the hearth.
Do not add or change anything to the ceramic logs.
Make sure the pilot light is uncovered at all times, and
that it can reach the main burner freely.
Avoid finger marks
Avoid leaving finger marks on the glass after placing
the ceramic logs and closing the door. Finger marks
will burn in the glass and can not be removed later.
Advertenties
Hoofdstukken
Inhoudsopgave
