Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
handleiding
1. top with suspension for 2 fixtures, fan, filter and switch box
2. timer box
3. side panels with uprights and support profiles for armatures
4. rear panels
5. H profiles for connecting rear panels
6. intermediate ring consisting of 4 profiles and 4 corner pieces
7. air inlets
8. socket for pumps and propagators
9. bottom pannel glued in profiles
10. 8 cm aluminum feet
11. adjustable feet
The G-cloner consists of:
- upper part with suspension for 2 armatures, ventilator, filter and timer box
- bottom plate glued in profiles
- intermediate ring consisting of 4 profiles and 4 corner pieces
- 4 x side panels with uprights
- 4 x back panels with a white plastic H-connection profile
- 4 doors inc. handles
- 3 x shelves with each 2 x Sylvania Eco Twin, 48Watt, 1500mm fixtures (4 x for the version without watering
system)
- 6 x G-tools air inlets
- Instructions for use
Extra parts for version with watering system:
- 3 x Danish bottom 160 x 63 cm with grommet, overflow, tap and quick couplings.
- 62-liter water tank with lid.
- RP 1400 lifting pump with connecting hose and quick release coupling
- RP 2 air pump with bubbles
- Black tyleen supply hose with connections for Danish bottoms and metering valves.
- Grey 20mm PVC overflow protection.
- Digital timer for setting the watering sessions
- 2 x 64/50 heated propagator including thermostat
- 1 x rack with 1 x G-bars, 50-Watt fixture
a.
Open the boxes and check all components for presence and damage.
b.
Place the bottom of the cabinet in the desired location and make sure it is horizontal.
c.
Take 2 side plates (with the aluminum uprights) and place them on the plastic corner pieces of the
bottom plate. The side plate with the socket should be placed at the bottom right.
d.
Place the two back plates with the round holes and connect them to the white plastic H-profile.
e.
Place the air inlets (see chapter 4).
f.
Place the intermediate ring.
g.
Take 2 side plates (with aluminum posts) and place them on the plastic corner pieces of the intermediate
ring.
h.
Place the two back plates (without the round holes) and connect them with the white plastic H-profile.
i.
Place the top box with the extractor and carbon filter on the posts. When doing so, make sure the timer
box is on the right side and the cable comes out the back of the cabinet.
www.g-tools.nl
Advertenties
Inhoudsopgave
