Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Only use this heater for its intended purpose and as described in this instruction
24.
manual.
Not abiding by instructions 22, 23 & 24 may lead to damage, fire and/or personal injuries. A failure to adhere to
these rules also immediately nullifies the guarantee and vendor, importer and/or manufacturer do not take
responsibility for any of the consequences!
Description
Location and Connection
Remove all packaging material and keep out of reach of children. After removing packaging, check the appliance for
damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not use the appliance, but
contact your vendor for inspection or replacement.
Choose a suitable location for the heater which is at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).
Make sure a functioning heater is always placed on a solid, flat and horizontal surface.
something like that!
Check if the control switch is set to 'OFF' (O).
Fully extend the power cord and plug into a suitable 230V socket. To prevent the circuit overloading, check that no
other appliances are connected to the same group.
Set-up and Operation
Turn the thermostat dial to maximum (clockwise as far as possible).
Switch the heater on by pushing the control switch to one of the following two positions:
I Heating at half power (1000W (KEL-KER 2000) or 1500W (EK3K))
II Heating at full power (2000W (KEL-KER 2000) or 3000W (KEL-KER 3000))
It is most economical to heat the space at full power, then to switch to half power to maintain the temperature.
Both at half and full power, the fan rotates at the same speed; the difference between the two lies in the
number of heating elements in use.
1. House
2. Handle
3. Outlet grill hot air
4. Electrical cable with plug
5. Operation panel (Back side)
6. Control switch
7. Thermostat dial
Inside: PTC-element and fan
13
Never on moving vehicles or
Advertenties
Inhoudsopgave
