Download Inhoudsopgave Inhoud Print deze pagina

Technical Data; General Safety Instructions - Kelfort KEL-KER 2000 Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Technical data

Type
Supply voltage
Maximum capacity
Settings Thermostat
Protection class
Dimensions
Weight

General safety instructions

Before using the machine, carefully read this entire instruction manual. Keep this booklet in a safe place for reference.
1.
Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a damaged
2.
heater, but send it back to your dealer for replacement.
This heater is exclusively intended for normal household and light commercial use. Avoid dusty conditions.
3.
This heater in not suitable for use in wet or damp spaces such as bathrooms and laundry rooms. Do not place the
4.
heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources of moisture. Make sure it cannot
fall into water and prevent water from getting into the heater itself. If, at any time, the heater does fall into
water, unplug it immediately! Do not use a heater that has a damp interior but have it repaired. Never immerse the
heater, cord or plug in water and never touch it with wet hands. Do not use the appliance if power cord or plug is
wet.
The supply voltage and utility frequency, specified on the machine, need to match those of the socket that is used. The
5.
electrical installation needs to be protected by a residual current device (max. 30 mAmp). Only connect the heater to an
earthed socket with sufficient capacity: ≥ 10A KEL-KER 2000) or ≥ 16A (KEL-KER 3000)).
Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any part of the
6.
heater and prevent it from heating up any other way. Do not run the cord underneath carpeting; do not cover it
with mats, carpet strips, or similar and make sure it is not placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do not lead the cord around sharp corners and do not roll it up
too tightly after use!
If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an extension
7.
cord is unavoidable, then make sure it is an undamaged, approved extension cord with a minimum permissible
power of 2000 Watt/10Amp. (KEL-KER 2000) or 3000W/16A (KEL-KER 3000). To prevent overheating, always fully
extend the cord!
To prevent the circuit being overloaded and fuses being blown, make sure no other appliances are connected to
8.
the same socket or wired to the same electrical circuit as the heater.
English
KEL-KER 2000
230 / 50
Volt/Hz
2000
Watt
0 - 1000 – 2000
Watt
+
IP21
18,7 x 17,7 x 19,3
cm
2,1
kg
11
KEL-KER 3000
230 / 50
3000
0 – 1500 - 3000
+
IP21
23,8x23,8x24,8
3,4

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

Kel-ker 300015147171514718

Inhoudsopgave