Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
The compressor operates contin-
ually.
Water flows inside the refrigera-
tor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest
brand-mark service.
www.zanussi.com
Possible cause
The lamp is defective.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
There is no cold air circulation
in the appliance.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Refer to "Levelling".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature
decrease to room temperature be-
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
illustration).
Solution
19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
