Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Ensure not to use other air-consuming appliances, such as heaters, cooking hoods,
bathroom ventilators, in the same room or in the house while the stove is burning; or
make sure to have an extra ventilation grille installed for these appliances.
3.1.3.
Floor, walls
A safe distance should be kept between the stove and combustible materials such as
wooden walls and furniture. If you purchased a freestanding stove, this distance should
be at least forty centimetres.
The appliance shall be installed on floors with an adequate load-bearing capacity.
Combustible floors require sufficient protection against radiant heat by means of a
fireproof protective plate. Rugs and carpets must be kept at a distance of at least eighty
centimetres from the fire.
3.2.
Preparing the stove
Please inspect the stove for damage caused during transport immediately after delivery
and notify your distributor in case there are any defects. Do not put the stove into
operation in the meantime.
In order to avoid damaging the stove during installation and to make handling of the
stove easier, it is recommended to remove previously all loose parts (fire-resistant
bricks, grille, ashtray, ...) from the stove. Note the location of those parts while
removing them, so that you have no difficulties in reassembling the parts later on.
The stove will be supplied with the following parts:
A set of legs
A connection collar with fastening brackets
A "cold hand" to remove the ashtray
A "cold handle" to open the door
A small shovel to remove ashes
3.2.1.
Assembling and installing the legs (see sketch)
Assemble both parts of the legs at the requested length using
the M6 bolts and rings. Tilt the stove backwards and mount the
legs on the pre-installed M8 bolts on the bottom plate of the
stove.
3.2.2.
The smoke outlet
The stove can be connected to the chimney at the rear or at the top.
Depending on the position chosen, one opening can be covered with the blanking plate
supplied, the other one can be equipped with the connection collar supplied. Use the
fixings supplied and be sure to tightly seal the connection collar and the blanking plate
to the stove by means of the kit or paste supplied.
DRU 44MF
29
03.27647.000
Advertenties
Inhoudsopgave
