Zodiac Z550iQ Snelstartgids pagina 21
Verberg thumbnails
Zie ook voor Z550iQ:
- Gebruikshandleiding (228 pagina's) ,
- Installatie en gebruikshandleiding (28 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5
Operation
Open the hydraulic circuit
• Close valve B gradually,
• Open valves A, C and D fully then valve E by half (the air which has built up in the heat pump condenser and the
filtration circuit will bleed out). If valves D and E are not present, open valve A wide and close valve C by half.
• Connect the power supply to the heat pump.
• If the heat pump is on standby, press for 3 seconds; the splash screen appears for 4 seconds then the home screen
is displayed. A 2-minute timer will start.
• Set the desired temperature.
Connecting to the iAquaLink+ ™ app
Mobile device
The Z550iQ heat pump can be remotely controlled from a smartphone or tablet, via the iAquaLink+™ app
available for iOS and Android systems. Before connecting to the iAquaLink+™ app, ensure that you:
• Use a Wi-Fi-enabled smartphone or tablet.
• Use a Wi-Fi network with a reasonably strong signal when connecting to the heat pump: the Wi-Fi signal
must be detectable at the place where the appliance is used. If this is not the case, a technical solution must
be provided to amplify the existing signal.
• Rest close to the appliance and have your home Wi-Fi network password at the ready.
Download the
iAquaLink+™ app
Home Wi-FI network
The screen
+
displays "bLE"
Long press
CAUTION : An incorrect by-
pass setting may cause the heat
pump to malfunction.
Heat pump
Open the application and follow the steps
described in the app to add the heat pump
❶ Installation
❷ Use
21
Advertenties
Inhoudsopgave
