Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN User Guide
Compressor is
running
continuously,
but little/no
pressure builds up
Compressor is
running, pressure is
indicated on the
pressure gauge, but
the tools are not
running
Compressor starts
up briefly or hums
when the switch-on
pressure is reached
and then switches
off automatically
Compressor is
running
continuously
STIER Industrial GmbH
Power supply not available
Power supply too low
Defective pressure switch
Carbon brushes worn out
Ambient temperature too low
Motor is overheating
Impeller cannot rotate due to
piston seizure
Defective capacitor
Check valve leaking
Cylinder head gasket leaking
Check for any leaks in
connections and/or lines.
Condensate drain plug open or
missing
Air filter clogged.
Too much condensate in the
pressure vessel
Hose connections leaking
Insufficient pressure set on the
pressure regulator
Quick coupling leaking
Air consumption of the
pneumatic tool is too high
Mains power cable is too long or
the cross-section of the cable is
too small
Air filter clogged.
Air consumption of the
pneumatic tool is too high
Check the cable, mains plug, fuse and
socket
Avoid extension cables that are too long.
Use an extension cable with a sufficient
core cross-section
Have the pressure switch replaced by
qualified personnel
Replace carbon brushes
Do not operate the device at outside
temperatures of below +5°C
Allow the motor to cool down and
eliminate the cause of the overheating if
necessary
Contact qualified personnel
Have the capacitor replaced by qualified
personnel
Unscrew the check valve hex head,
clean/replace the seat and rubber
plunger and reinstall
Check for damaged cylinder head
gasket and, if necessary, ensure proper
functioning of the gasket by tightening
the screws
Check connections, have broken seals
replaced at a specialist workshop
Tighten the screw by hand. Check the
seal on the screw, replace if necessary
Clean or replace filter
Drain condensate
Check compressed-air hose and tools,
replace if necessary
Turn up the pressure regulator
Check, replace if necessary
Check air consumption of the consumer,
contact customer service
Check mains connection length and
cable cross-section
Clean or replace filter
Check air consumption of the pneumatic
tool; contact customer service
25
EN
Advertenties
Hoofdstukken
Inhoudsopgave
