GB
Remove the spigot and clean the filter mouth carefully.
Now put the valve as well as the joint onto the upper edge of the filter. The connection between the
upper part of the filter or valve is made with the collar. The collar is secured with a screw and a nut
(see fig. 5 & 6).
Fig 5
Fig 6
Connect the pipe with the pump and valve properly (fig. 7 & 8).
Fig 7
Fig 8
Finally, install the hoseconnectors and hoses that connect the filter system to the pool. Make the
joints watertight with PTFE tape.
MV-1088-3-2019 . © All rights reserved Swim & Fun Scandinavia ApS
Side 64