Advertenties
EN 36
PROBLEM
4. The engine
does not start
5. The engine
stops
6. Starting is difficult
or the engine runs
erratically
7. Weak engine per-
formance during cut-
ting
8. Engine stops when
blade is engaged
All manuals and user guides at all-guides.com
LIKELY CAUSE
– earth connections of the microswitches
disconnected
– you are not ready for starting
– faulty fuel supply
– faulty ignition
– earth connections of the microswitches
disconnected
– fault in carburation
– forward speed too high in relation to
cutting height
– you are not ready to engage the blade
TROUBLESHOOTING
SOLUTION
– check connections
– check that the conditions allowing the
start are met (☛ 5.2.a)
– check the level in the tank (☛ 5.3.3)
– check the wiring of the fuel open com-
mand
– check the fuel filter
– check that spark plug caps are firmly
fitted
– check that the electrodes are clean
and have the correct gap
– check connections
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill with fresh
fuel
– check and, if necessary, replace fuel
filter
– reduce the forward speed and/or raise
the cutting deck (☛ 5.4.5)
– check that the safety requirements are
met (☛ 5.2.b)
Advertenties
