Advertenties
ORIGINAL OPERATING INSTRUCTIONS
DX 460 GR powder-actuated tool for grating applications
It is essential that the operating instruc-
tions are read before the tool is operated
for the first time.
Always keep these operating instructions
together with the tool.
Ensure that the operating instructions
are with the tool when it is given to other
persons.
Description of main parts
@ Exhaust gas piston return unit
; Guide sleeve
= Housing
% Cartridge guideway
& Power regulation wheel release button
( Power regulation wheel
) Trigger
+ Grip
§ Piston return unit release button
/ Ventilation slots
: Piston rings
· Piston *
$ Replaceable fastener guide nosepiece *
£ Fastener guide release button
| Buffer *
* These parts may be replaced by the user/operator.
Contents
1. Safety precautions
2. General information
3. Description
4. Accessories
5. Technical data
6. Before use
7. Operation
8. Care and maintenance
9. Troubleshooting
10. Disposal
11. Manufacturer's warranty – DX Tools
12. EC declaration of conformity (original)
13. CIP approval mark
14. Health and safety of the user
Printed: 12.08.2013 | Doc-Nr: PUB / 5069839 / 000 / 02
All manuals and user guides at all-guides.com
1. Safety precautions
1.1 Basic safety instructions
In addition to the safety precautions listed in the indi-
vidual sections of these operating instructions, the
following points must be strictly observed at all times.
1.2 Only use Hilti cartridges or cartridges of equiva-
The use of cartridges of inferior quality in Hilti tools may
lead to build-up of unburned powder, which may explo-
de and cause severe injuries to operators and bystan-
ders. At a minimum, cartridges must either:
a) Be confirmed by their supplier to have been suc-
NOTE:
● All Hilti cartridges for powder-actuated tools have
● The tests defined in the EN 16264 standard are system
or
b) Carry the CE conformity mark (mandatory in the EU
See packaging sample at:
www.hilti.com/dx-cartridges
1.3 Use as intended
The tool is designed for professional use in fastening
applications in construction where nails, threaded studs
and composite fasteners are driven into concrete, steel
Page
and sand-lime block masonry.
1
3
3
4
1.4 Improper use
6
● Manipulation or modification of the tool is not per-
6
missible.
7
● Do not operate the tool in an explosive or flammable
8
atmosphere, unless the tool is specially approved for
such use.
10
● To avoid the risk of injury, use only original Hilti fas-
12
teners, cartridges, accessories and spare parts or those
13
of equivalent quality.
13
● Observe the information printed in the operating
13
instructions concerning operation, care and mainte-
14
nance.
lent quality
cessfully tested in accordance with EU standard EN
16264
been tested successfully in accordance with EN 16264.
tests carried out by the certification authority using
specific combinations of cartridges and tools.
The tool designation, the name of the certification aut-
hority and the system test number are printed on the
cartridge packaging.
as of July 2013).
en
1
Advertenties
