Inhoudsopgave
Advertenties
Before refitting the brackets on the opposite side of
the cabinet, move the threaded pin on the hinge
bracket to the other threaded hole. Remove the
threaded pin under the control panel using a Phillips
screwdriver and move it to the opposite side. (3).
Refit the door and screw the bottom hinge into
position using a Phillips screwdriver. Refit the
adjustable feet and, finally, refit the door handle.
Starting up
If during transport the freezer has been laid down, or
if it has been stored in cold surroundings (colder than
+5°C) it must be allowed to stabilise for at least two
hours before being switched on.
Start the freezer by plugging into a wall socket.
Important! If the mains lead has been damaged, it must
be replaced with a corresponding type supplied by
Gram A/S or one of Gram's service centres.
Changing the tempera-
ture
6
The control panel is positioned behind the door at the
top of the cabinet. The switch furthest to the right
starts the freezer. The green lamp lights up, showing
that power is on. The thermostat knob can be set
from 1 (warmest) to 7 (coldest).
When the appliance is started the thermostat should be
in its middle setting „4". After an hour or two the cabinet
will have cooled down. If a lower temperature is required,
turn the thermostat knob towards „7". If a higher
temperature is required, turn the knob towards „1".
The compressor is switched off when the thermostat
knob setting is „0".
The red lamp lights up when the temperature in the
cabinet is not in accordance with the thermostat setting.
All manuals and user guides at all-guides.com
Please note!
When fresh items are placed in the cabinet, the
temperature will increase sufficiently for the red
warning lamp to light up. The lamp will stay lit until
the temperature again falls to below approx. -15°C.
The most effective freezing down is achieved by
pressing the „quick-freeze" switch ¹ 24 hours be-
fore items are to be placed in the cabinet. The
yellow lamp º remains lit for as long as „quick-
freeze" is switched on.
When freezing down is completed - after a day or
two depending on the quantity of items placed in
the cabinet - switch off „quick-freeze", and the
yellow lamp will go out.
Please note!
nuously during freezing down.
Specifically for Fresh line models
The control panel and thermostat knob are located
on the top panel. All functions are set using a single
knob which can be turned from "1" (least cold) to
"7" (coldest). Turning the thermostat knob to "S"
activates the quick-freeze function. For further
details, see "Freezing down".
NB!
Pack your frozen foods in airtight and watertight
material in order to avoid drying out. Portions should
be as flat as possible to allow rapid freezing down.
Brief temperature variations are normal and occur when:
- the cabinet is filled with fresh items,
- the door is left open for longer periods.
Items of food in the cabinet will not be affected by
these variations and the temperature will quickly
return to normal.
25
Freezing down
The compressor runs conti-
Brief temperature varia-
tion
GB
Advertenties
Inhoudsopgave
