Inhoudsopgave
Advertenties
If two freezers or a freezer and a refrigerator are
placed side by side, there must be at least 2 cm
clearance between them.
If the appliance is not built in but positioned with its
door hinge side against a wall, there should be at
least 5 cm between the appliance and the wall in
order to allow the door to open easily.
The freezer must not be laid horizontally while being
transported or moved. If the appliance has been tilted
more than 40°, the power supply must not be
connected until the appliance has stood upright for at
least two hours.
3
Electrical connection
The appliance is intended for connection to alternating
current. The connection values for voltage (V) and
frequency (Hz) are given on the nameplate
the cabinet.
Power must be connected via a wall socket with switch.
The wall socket should be easily accessible.
All earthing requirements stipulated by the local
electricity authority must be observed. The appli-
ance plug and wall socket should then give cor-
rect earthing. If in doubt, contact your local suppli-
er or an authorised electrician.
WARNING
The flexible cord (mains lead) fitted to this appliance
has three cores for use with a 3-pin 13-amp or 3-pin 15-
amp plug. If a BS 1363 (13-amp) fused plug is used, it
should be fitted with a 13-amp fuse.
IMPORTANT
The cores in this mains lead are coloured in accord-
ance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the col-
our markings identifying the terminals in your plug.
All manuals and user guides at all-guides.com
Proceed as follows:
Connect the GREEN-AND-YELLOW core to the plug
terminal marked "E" or by an earth symbol, or coloured
GREEN or GREEN-AND-YELLOW. Connect the
BLUE core to the plug terminal marked "N" or coloured
BLACK. Connect the BROWN core to the plug terminal
marked "L" or coloured RED.
Illustration
the door from right-hinged to left-hinged - or vice versa.
Take off the table top by removing two screws at the
front of the cabinet and three at the back.
in
4
Lay the appliance on its back with the door up.
Remove the door handle.
Unscrew the adjusting screws and take the brackets off.
Remove the door.
Take off the upper hinge bracket and refit it on the
opposite side of the cabinet.
Replace the door.
Move the pin on the hinge bracket to the other
threaded hole before refitting the hinge brackets
on the opposite lower side of the cabinet.
Remember to replace the shim washer on the
hinge pin.
Refit the adjusting screws and the door handle.
Replace the table top.
Specifically for Fresh line
Switch the cabinet off by turning the thermostat
knob to "0". Empty the cabinet and begin by
removing the door handle. Tilt the cabinet 40° in
order to gain access to the lowest hinge. Remove
the adjustable feet. Remove the three screws
holding the lowest bracket in place using a Phillips
screwdriver. (1). Remove the door and unscrew
the three screws from the bracket on the base on
the cabinet (2).
24
You can change the
door from right-hinged
to left-hinged or vice
versa yourself
5
shows how easy it is to change
GB
models 5A
Advertenties
Inhoudsopgave
