Inhoudsopgave
Advertenties
Pause and goes out (the digits 0 and 1 are indica-
ted by a single ash of the LED, although the LED
only ashes very brie y for the digit 0).
6. Special Functions
6.1 Punch Through Channel
The Punch Through Channel allows the Prog+ or
Prog- commands to bypass the currently controlled
device and switch the channels on a second device.
All other commands remain unin uenced.
To activate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "Prog+" key.
• Press desired device mode key (e.g. SAT).
• Release "Prog+" (the indicator ashes once if
the setting is activated).
To deactivate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "Prog-" key.
• Press desired device mode key (e.g. SAT).
• Release "Prog-" (the indicator is ashing twice
if the setting is deactivated).
6.2 Punch Through Volume
The Punch Through Volume allows the VOL+ or
VOL- commands to bypass the currently controlled
device and adjust the volume on a second device.
All other commands remain unin uenced.
To activate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL+" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL+" (the indicator ashes once if
the setting is activated).
4
To deactivate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL-" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL-" (the indicator is ashing twice if
the setting is deactivated).
6.3 Macro Power
Macro Power enables you to turn two TV/STB
devices on/off simultaneously.
To activate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator ashes once if
the setting is activated).
To deactivate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator is ashing
twice if the setting is deactivated).
7. LEARN MODE
This remote control is equipped with a learning
function. Thus, you could learn functions of your
original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to
be in good condition. Replace them if necessary.
• Place the remote controls with the infrared
diodes so that they point towards each other.
• Where necessary adjust the height of both
remotes so that infrared diodes are properly
aligned.
• The distance between the remote controls should
be about 3 cm.
ROC1117GRU
ZAPPER
ORIGINAL
ca. 3 cm
Advertenties
Inhoudsopgave
