Inhoudsopgave
Advertenties
684786
Smart Jump Start Protector Unit (Fig. II)
Green and Red LED Status
Condition Description
Solid Green LED
Cable/clamp polarity correct,
the Lithium Jump Starter
voltage is above 11V, and
vehicle battery is above low
limit threshold
Green LED blinking and
Vehicle battery is low
Smart Jump Start Protector
Unit beeping
Solid Red LED and Smart
Connection is incorrect.
Jump Start Protector Unit
Cable/clamps are in reverse
beeping
polarity, a vehicle battery
short has been detected,
or incorrect Lithium Jump
Starter voltage
No LEDs or beeping
Vehicle's battery may be
damaged
WARNING: If the Lithium Jump Starter becomes warm to the touch at any time, disconnect
the Lithium Jump Starter from the cables then allow to cool fully before re-attempting the next
jump start.
Maintenance
Note: The Lithium Jump Starter comes equipped with an internal rechargeable lithium polymer
battery. This battery is not consumer replaceable, and must be disposed of when the battery can no
longer hold charge. Correct charging practices will prolong the life of the battery.
• Charge the device fully at least once every 3–4 months if not used regularly to maintain the life
of the lithium polymer battery
Cleaning
• Keep your Lithium Jump Starter clean. Always clean dust/particles away
• Use a soft brush or dry cloth to clean the device
• Make sure that the positive and negative lead clamps are kept clean. Dirty electrical contacts will
severely impair the performance of this product
• A soft wire brush can be used to clean the clamps
• NEVER use water or alcohol-based cleaners to clean the device
Storage
• Store fully charged. The unit will hold charge for 6 to 12 months, but should always be charged
before the next use after being stored for a long period of time
• Store this tool carefully in a secure, cool, dry place (-10°–30°C / 14°–86°F) out of the reach of
children
• If storing in a moving vehicle, ensure that the unit, particularly the Lithium Polymer Battery Pack
(1), cannot move around freely
12V Lithium Jump Starter & Powerbank
Disposal
• Always adhere to national regulations when disposing of power tools that are no longer
Action
functional and are not viable for repair.
• Do not dispose of power tools or other waste electrical and electronic equipment (WEEE) with
Can now attempt to jump
household waste
start the vehicle
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Press Jump Start Protector
Boost Button. Wait until
Green LED is solid then,
Web: www.silverlinetools.com
within 30 seconds, attempt
to jump start the vehicle
UK Address:
Toolstream Ltd.
Do not attempt to jump start
the vehicle. Disconnect High
Boundary Way
Current Connector Plug and
Lufton Trading Estate
remove clamps from the
Yeovil, Somerset
vehicle's battery terminals.
BA22 8HZ, United Kingdom
Reconnect clamps to the
vehicle's battery in correct
polarity (see ' J ump starting
EU Address:
a 12V vehicle') then connect
Toolstream B.V.
the High Current Connector
Holtum-Noordweg 11
Plug to the Lithium Jump
Starter
Unit 4
Note: The source of this
6121 RE Born
problem must be found and
The Netherlands
resolved before any more
attempts are made to jump
start the vehicle using the
Lithium Jump Starter
Disconnect High Current
Connector Plug and remove
clamps from the vehicle's
battery terminals. Reconnect
in correct polarity to the
vehicle's battery terminals
and Lithium Jump Starter. If
there is no solid Green LED,
press the Boost Button.
silverlinetools.com
15
Advertenties
Inhoudsopgave
