Inhoudsopgave
Advertenties
4
INSTALLATION
Attention: Installation should be performed by
qualified service personnel only in accordance with
the National Electrical Code or applicable local
codes.
4.1
Removing Module From Carton
Refer to ILLUSTRATIONS for component description.
CAUTION: Keep in carton until ready to install
in backbox. Be sure to observe all safety measures
for static control when working with this unit
while out of its enclosure. Otherwise, static
damage may result.
For removal from carton and installation instructions, see
LTC 0809 Series Camera Module Installation under
INSTALLATION in the Instructions for Use supplied with
the applicable LTC 7460 Series Ceiling Mount ordered.
CAUTION: Do not handle the unit by the circuit
board because this may result in physical damage
to the unit.
5
OPERATION
5.1
Camera Control
These units, as shipped, are factory adjusted as described below:
• Line-lock mode enabled with zero degree phase delay.
• AGC on.
• Backlight compensation off.
• Electronic shutter off.
• Automatic white balance on.
5.2
Changing Operating Modes
The AutoDome unit operating modes can be changed using
either a TC8135B Series Controller/Follower or an Allegiant ®
series keyboard. An Allegiant series keyboard is required to take
full advantage of all the various features available. See
AutoDome Commands for description of various operating
adjustments.
All manuals and user guides at all-guides.com
5.3
PAN & TILT - COMMANDS USING AUXILIARY CONTROLS
Receiver/Driver Aux
Function
Scan
Auto-Pan
Pre-Position
Tour
Return Home
Set Scan/auto-
pan speed
Set tour period
Auto-Speed
Auto-Pivot
Enable
Field of View
Optimize
LENS - COMMANDS USING AUXILIARY CONTROLS
Lens Function
Iris Control
Focus Control
Auto-iris ALC adj
Auto-iris Level adj 11
Auto-focus
Activation
Auto-iris Activation 13
Spot Focus
CAMERA - COMMANDS USING AUXILIARY CONTROLS
Camera
Function
Backlight
Compensation
Shutter
Auto shutter
activation
White Balance
Red Adjust
Blue Adjust
R-Y Hue Adjust
B-Y Hue Adjust
Fixed White
Balance
Factory Default
Settings
Adjust LL Phase
Delay
Sync Mode
AGC
Vertical Aperture
Adjust
1.2
AutoDome Commands
Description
No.
1
Auto-pan without
limits
2
Auto-pan between
limits
8
--
9
return to home
upon inactivity
14
--
15
Sets pause
between tour
callups
16
Enables/disables
auto-speed
18
Enables/disables
auto-pivot
45
---
Aux No. Description
3
--
4
--
10
--
--
12
Activates AF
upon movement
Activates AI
upon movement
17
Activates Spot
Aux No.
20
23
24
30
31
32
33
34
35
40
41
42
43
44
On/Off
Notes
On/off
5, 8
On/off
8
On/off
8
On/off
2, 7
Inc/dec
2, 7
Inc/dec
2, 7
On/off
2, 7
On/off
2, 7
On/off
2, 7
On/Off
Notes
Auto/
1, 9
manual
Auto/
1, 9
manual
Peak/ave 1, 7
Inc/dec
1, 7
On/off
2
On/off
2
On/off
2, 7
On/Off
Notes
On/off
1, 10
On/off
1, 7
On/off
2, 7
Auto/
7
manual
Inc/dec
1, 7
Inc/dec
1, 7
Inc/dec
3, 7
Inc/dec
3, 7
Indoor/
outdoor
1, 7
Set/---
1,3, 7
Inc/dec
3, 7
ll/xtal
3, 7
On/off
3
Inc/dec
7
Advertenties
Hoofdstukken
Inhoudsopgave
