Inhoudsopgave
Advertenties
INSTALLATION
Rules to follow:
• Put the machine on the floor (maximum incline of 10°.)
• Ensure the work area has sufficient ventilation for welding, and that there is easy access to the control panel.
• The machine must be placed in a sheltered area away from rain or direct sunlight.
• The machine must not be used in an area with metal dusts.
• The machine protection level is IP23, which means :
- Protection against acess to dangerous parts from solid bodies of a ≥12.5mm diameter and,
- Protection against the rain inclined at 60% towards the vertical.
These devices can be used outside in accordance with the IP23 protection index.
• Do not use the machine when the temperature is > 40°C.
• The power cables, extensions and welding cables must be fully uncoiled to prevent overheating.
The manufacturer does not incur any responsability regarding damages to both objects and persons that result from an incorrect
and/or dangerous use of the machine.
MAINTENANCE / RECOMMENDATIONS
• Maintenance should only be carried out by a qualified person.
• Ensure the machine is switched off by unplugging it, and then wait 2 minutes before carrying out maintenance work. High
Voltage and Currents inside the machine.
• Remove the casing 2 or 3 times a year to remove any excess dust. Take this opportunity to have the electrical connections checked by a qualified
person, with an insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or an equally qualified person to prevent danger.
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
• Do not use these machines to unfreeze pipes.
INSTALLATION – PRODUCT OPERATION
Only qualified personnel authorized by the manufacturer should perform the installation of the welding equipment. During set up, the operator must
ensure that the machine is unplugged.
HARDWARE DESCRIPTION (FIG-1)
The Exagon 400 CC-CV is a three phase inverter welder which, depending on its equipment, can do :
- Electrode welding (MMA)
- Semi automatic welding (MIG/MAG/flux cored wire)
- Tungsten electrode welding (TIG)
- Carbon electrode gouging
The TIG process requires gas shielding (Argon).
The MMA process can weld any type of electrode : rutile, basic, cellulosic, stainless and brass.
The 400 CC-CV can be equipped with a remote control or foot pedal.
1-
Man to Machine Interface
2-
+ polarity plug
3-
- polarity plug
4-
Remote control cable connector
CONTROL BOARD (MMI) (FIG-2)
1-
Voltage display
2-
Active risk reduction system indicator (VRD)
3-
Current display
4-
Overheat indicator
5-
Disruption of normal operations indicator
6-
Main setting knob.
7-
Arc-force setting indicator
8-
Variable inductance setting indicator
9-
Indicators
10- Secondary setting knob
11- Locked keypad indicator
12- Locked keypad button
All manuals and user guides at all-guides.com
EXAGON 400 CC/CV
5-
Wire feeder control cable connector
6-
Transport handles and lifting rings
7-
On/off switch
8-
Power supply cable
13-
Remote control activation button
14-
Active remote control indicator
15-
Basic electrode indicator
16-
Rutile electrode indicator
17-
Cellulosic electrode indicator
18-
MMA mode indicator
19-
MMA pulse mode indicator
20-
Voltage mode indicator (CV)
21-
Semi-automatic mode indicator
22-
TIG mode indicator
23-
Gouging mode indicator
24-
Selection mode button
EN
17
Advertenties
Inhoudsopgave
