Inhoudsopgave
Advertenties
English
NOTE
NOTE
The frost watcher range of electric heaters is designed
to provide frost protection within buildings.
This product must not be specified for indoor space
heating to reach and maintain a certain level of thermal
comfort for human beings.
The installation of this heater must be carried out
by a competent electrician in accordance with the
current safety regulations.
The heater may only be used for heating room air in
enclosed spaces.
Repairs to the appliance, or any other interven-
tions, may only be performed by qualified persons
or the after-sales customer service.
In the event of any defect or during extended peri-
ods of non-use, the heater must be disconnected
from the power supply. Deactivate or remove fuse.
Do not use the appliance in areas where flammable
gases or liquids are stored or used.
2. Wall Mounting
The device plug must be accessible after installation.
The heating device must be aligned horizontally and in-
stalled on a vertical wall (see illustration).
Make sure that the inflow and outflow of air at the top
and bottom of the device are unimpeded
In addition, a minimum clearance of 500 mm between
inflammable objects e.g. curtains, towels or heat-sensi-
tive plastics and the front of the unit must be main-
tained.
Installation below a wall socket is not permissible.
Minimum clearances must be observed.
It is not permissible to install the device in protection
zones as defined in current regulations.
EN-6
All manuals and user guides at all-guides.com
.
1909/E
2.1 Mounting Instructions
NOTE
NOTE
Use the original wall bracket supplied!
Drill the mounting holes and insert dowels.
Screw the wall bracket into place.
Hang the heating device in place.
Screw the heating device into place on both sides
of the wall bracket.
3. Electrical Connection
The voltage specified on the type plate must match the
present mains voltage.
If the power line of this device is damaged, it must be
replaced by the manufacturer or after-sales service, or
else by a similarly qualified person, in order to prevent
risks. The device plug must always be accessible.
To prevent danger by accidental resetting of the ther-
mal tripping unit, this device must not be supplied via
external switching devices (e.g. timers) or connected to
a circuit that is regularly switched on and off by the util-
ity company.
FW 550 S
www.dimplex.de/en
Advertenties
Inhoudsopgave
