Advertenties
Introduction
This instrument is manufactured with the latest technology and needs no particu-
lar maintenance. Consort certifies that this instrument was thoroughly inspected
and tested at the factory prior to shipment and found to meet all requirements
defined by contract under which it is furnished. However, dimensions and other
physical characteristics may differ.
The normal operating temperature should be between 0° and 40°C. Never use
the instrument in a room with high humidity (>95 %) or at very low temperatures
(condensation water!).
Connect the instrument only to an earthed power line. The required power source
is indicated on the label at the back of the instrument. Do not cut and splice
the power cord. When removing the power cord from the wall outlet, be sure to
unplug by holding the plug attachment and not by pulling the cord. Do not hold
the plug by wet hand.
Manufacturer
Consort nv
Parklaan 36
Tel (+32)(14)41 12 79
B2300 Turnhout
Fax (+32)(14)42 91 79
Belgium
E-mail: info@Consort.be
Warranty
This instrument (excluding all accessories) is warranted against defective material
and workmanship for a period of thirty-six (36) months from the date of shipment
ex factory. Consort will repair all defective equipment returned to it during the
warranty period without charge, provided the equipment has been used under
normal laboratory conditions and in accordance with the operating limitations
and maintenance procedures in this instruction manual and when not having
been subject to accident, alteration, misuse or abuse. A return authorisation must
be obtained from Consort before returning any product for warranty repair on a
freight prepaid basis!
Consort is not liable for consequential damages arising out of the use or handling
of its products.
Servicing
In the event of this instrument being returned for servicing, the owner is request-
ed to remove the power supply lead and NOT to send the following items unless
they are suspect:
Manual
Cables
Accessories
If serious malfunctioning occurs, stop using the unit immediately and consult your
local Consort dealer.
Keyboard
= Button for entering a value or for selecting a function.
Ù/Ú
SET/ENTER = Button for programming the desired parameters.
RUN/STOP = Button to start or stop an experiment.
5 /32
EV243
Advertenties
