Inhoudsopgave
Advertenties
Owner's manual
Prior to first use, please fully charge the battery.
Charging:
1. Make sure the device is turned off.
2. Make sure the device is placed:
• on flat surface,
• in a place with easy access to the power supply socket.
3. Connect one end of the charger into device's charging port.
4. Connect the other end into the power supply socket. The device will
issue a voice prompt.
5. During charging, red LED is on.
6. When charging is complete the device issues a voice prompt and blue
LED is on.
7. When charging is complete disconnect the charger from the device
and power supply socket.
Notes:
• Use only the included charger to charge the battery.
• Fully charge the battery after each use and store the device fully
charged.
1. Apply selected window cleaning agent or water on the surface to be
cleaned and clean it.
Note:
• To clean the selected surface you can use the sprayer with the
attached wiper head. First, make sure that all of the parts were
assembled correctly (see section Assembly – Accessories). Make sure
the water tank is filled with the selected window cleaning agent or
water. Then set the tip of the sprayer to the selected position: STREAM
(foam) or SPRAY (water mist). Spray the surface to be cleaned. Finally,
use the wiper head or the cloth to clean the surface.
• To clean the surface you can use TEESA cleaning supply.
2. Turn on the window vacuum cleaner by pressing and holding Power
button. Blue LED is on.
3. Place the rubber lip of the device on the surface to be cleaned and
using light pressure pull it from top to bottom across the surface.
Repeat this step until the surface is completely cleaned.
BEFORE FIRST USE
OPERATION
23
EN
Advertenties
Inhoudsopgave
