Inhoudsopgave
Advertenties
HANDLE INSTALLATION
To install the door handle follow the below steps:
1. Open the door of the appliance and move the door gasket
slightly to one side so that you can see two designated holes for
handle installation
2. Install the handle tightly as shown in the diagram above with
the two screws provided.
3. Ensure the door gasket falls back into place and that the door
opens and closes correctly.
BEFORE INSTALLING THE APPLIANCE
Before connecting your appliance to the power supply, check that the voltage stated on the
rating label of your appliance corresponds to the voltage in your home. A different voltage could
damage the appliance.
The plug is the only way to unplug the appliance and should therefore be accessible at all times.
To turn off main power to the appliance, detach the plug from the outlet. Do not immerse the
appliance, the power cord or the plug in water or other liquid.
The appliance must be grounded. The manufacturer is not responsible for damages that may
occur as a result of usage without grounding.
INSTALLING THE APPLIANCE
This appliance is designed to be free standing only.
Install the appliance in a dry, well ventilated room. The installation location should neither be
exposed to direct sunlight nor near a heat source, e.g. a cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each
side of the cabinet.
For uneven surfaces, front feet can be aligned.
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 10°C and 32°C.If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.
MOVING YOUR APPLIANCE
• Make sure that the appliance is unplugged from the mains socket. Remove all bottles and
shelves to avoid any shock.
• Always move the appliance vertically.
• After moving, wait for 30 minutes before plugging in the appliance.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of a
Advertenties
Inhoudsopgave
