Ice cubes making*
Refrigerator has an integrated ice cube production system (Fig. 17). To
make ice cubes, slide out the shelf with ice cube trays. Fill the trays with
a sufficient amount of water and slide the shelf back in. Ice cubes are
ready 24 hours after filling the trays with water. Turn the knob and the
ice cubes will automatically fall into a dedicated storage tray. If the ice
cubes do not fall out from the trays, turn the knobs again and release,
the spring will revert the trays to the initial position and the ice cubes will
fall directly onto the storage tray Repeat this action a few times.
Note, do not place food in the ice cube storage tray.
Water Dispenser*
Water dispenser dispenses chilled water without having to open the
refrigerator door. This helps to save energy.
Before first use
Before first use, clean the water tank inside the refrigerator (on the
inner side of the door), and the dispenser actuating lever in the recess.
Procedure:
1. Remove the water tank from the refrigerator chamber. (Fig. 21, item
1)
2. Remove the water tank lid. Wash the tank and its lid in warm water
with a small amount of mild detergent, then rinse thoroughly with clean
water and wipe dry.
3. After cleaning replace the lid and then reattach the water tank in the
refrigerator door.
4. Clean the dispenser lever using a soft cloth and lukewarm water.
Fill the water dispenser tank
In order to fill the tank with water, open the small flap in its cover (Fig.
21, item 2) and then pour drinking water making sure that the MAX
level marking is not exceeded and then close the small flap.
Use the water dispenser
The dispenser is equipped with a lock to prevent inadvertent use. Be-
fore dispensing, set the locking lever to the unlocked position (fig. 21,
item 3).
To dispense water, press the glass against the lever (fig. 21, item 4).
Adjust the stream of water by adjusting pressure on the dispenser le-
ver. Release the lever to stop dispensing water.
The dispenser water tank capacity: 3 l
- 19 -
*According to the model