Inhoudsopgave
Advertenties
Before any work on the tool, disconnect the plug from the mains!
Hold the outer flange (7) with the wrench (SW 19) and loosen the bolt (6) in
clockwise direction (left-hand thread!) with the wrench (SW 11). Then
remove the bolt outer flange and cutting disc.
Install the diamond wheel, outer flange and socket head bolt onto the
spindle. Hold the outer flange (7) with the wrench and tighten the bolt (6) in
counterclockwise direction with the wrench. Be sure to tighten the bolt
securely.
When mounting the diamond cutting discs, ensure that the direction of
rotation arrows on the diamond cutting disc match with the rotation
direction of the machine (see direction of rotation arrow on the
protective hood).
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a
sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastic components are marked according to their material,
which
makes
differentiated because of available collection facilities.
it
possible
to
remove
environmental
20
friendly
and
Advertenties
Inhoudsopgave
