Inhoudsopgave
Advertenties
Mounting the water supply
Loosen the depth adjustment screw (3) and pull shoe to it's minimum depth
of cut position. Remove the screw (8) located directly to the right of the
depth adjustment screw. Position the water supply (4) such that the holes in
the water supply are right and left of the diamond blade. Secure in place with
screw (8). DO NOT overtighten the screw; this could damage the water valve
assembly.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch (1)
Switching-off:
release the on/off switch (1)
Permanent Operation
Switching-on:
press the on/off switch (1) and, keeping it pressed, engage
the lock button (2)
Switching-off:
press the on/off switch (1) and let release it again
Instructions for Use
Adjust the cutting depth; see "Adjust cutting depth" section.
Place the sliding block on the workpiece to be cut without allowing the
diamond disc to come into contact with it. Then activate the tool and wait
until the diamond disc has reached full speed.
Align the left edge of the base (5) with your cutting line on the workpiece.
Now slide the tool in a flat and even manner across the surface of the
workpiece until the cut is completed.
To achieve a clean cut, maintain a straight cutting line and a steady speed of
advance. Curved cuts are not possible, as the diamond cutting disc will be
angled into the workpiece.
Do not strain the machine so heavily that it comes to a standstill.
Noticeable decreasing work progress and circular sparking are indications of
a blunt diamond cutting disc. Briefly cutting into abrasive material (e. g. lime-
sand brick or the EIBENSTOCK-diamond-sharpening-stone) can re-sharpen
the disc again.
Pre-selection of the Cutting Depth
Loosen the wing bolt (3) on the depth guide and move the base up or down.
At the desired depth of cut, secure the base by tightening the wing bolt (3).
18
Advertenties
Inhoudsopgave
