Inhoudsopgave
Advertenties
ENGLISH
-
Do not use corrosive cleaning liquids or disinfectants to clean the main brush.
-
It is recommended to replace the main brush every 6-12 months.
Mop roller
1. Remove the mixed tank from the robot vacuum cleaner and turn it upside down.
2. Pull the handle on the right side of the roller mop to remove the mop roller as shown in
Figure 20.
3. Use the self-cleaning brush to remove tangled hair. To remove surface stains, wash with
clean water. Make sure it is completely dry before refitting it.
4. Refit the mop roller.
Note:
It is recommended to replace the mop roller every 3-6 months for best cleaning results.
Robot vacuum cleaner sensors
Clean the sensors of the robot vacuum cleaner with a soft, dry cloth, including:
1. The four fall-detection sensors on the underside of the robot vacuum cleaner. Fig. 21
2. The ToF sensors, the laser sensor, and the front infrared sensors shown in Figure 22.
3. The charging and docking terminals on the rear of the robot vacuum cleaner. Fig. 23
Replacing the dirt-disposal bag
If the dirt-disposal bag is full, the
indicator light will flash slowly. Replace the old bag with
a new one following the below instructions:
1. Open the top cover of the self-emptying base, pull up the handle of the dirt-disposal bag,
and remove the bag. Fig. 24
Note: Remove the mixed tank from the robot vacuum cleaner before turning it upside down.
2. Discard the used dirt-disposal bag. Fig. 25
Note: it is recommended to change the dirt-disposal bag every 6-8 weeks.
3. Insert a new dirt-disposal bag into the self-emptying base as shown in Figure 26 and make
sure the handle is locked.
-
If the
indicator light changes to white, close the top cover of the self-emptying base.
If the
indicator light does not change to white, please re-insert the dirt-disposal bag
-
all the way.
Cleaning the water tank of the self-emptying base
1. Open the top cover of the self-emptying base and remove the water tank. Fig. 27
2. Open the top cover of the water tank and empty the waste and clean-water tank.
3. Clean the inside of both tanks and use the self-cleaning brush to remove stubborn stains.
Fig. 28
Note:
It is recommended to clean the water tank weekly to avoid bacterial growth or bad odours.
68
4. Add clean water to the clean-water tank. Do not fill up the water tank above the MAX mark
and below the MIN mark. Fig. 8
If you clean the water tank regularly every day, and the cleaning surface is smaller than 60 m
it is enough to add water up to the MIN mark each time.
5. After adding water, close the top cover of the water tank, secure the water-tank lock tab,
and place the water tank back in the self-emptying base.
Note:
-
Do not add hot water to the clean-water tank to avoid deformation of the tank.
If you notice water stains on the outside of the water tank, wipe them with a soft, dry cloth
-
before resuming use.
-
Do not use cleaning agents to prevent damage to the robot vacuum cleaner and self-
emptying base.
Self-emptying base
Infrared sensors
Check if the infrared lens and the charging terminals of the self-emptying base are dirty, and
wipe them with a clean, dry cloth to clean them if necessary. Fig. 29
Note:
It is recommended to clean both at least once a month.
Filter holder
Check the filter holder for lint or dirt build-up and remove it by wiping it with a clean, dry cloth.
Fig. 30
Note:
It is recommended to clean both at least once a month.
Removing the battery
Chemical substances contained in the battery of the appliance may pollute the environment:
remove it before disposing of the robot vacuum cleaner and take it to a collection point
designated by local authorities.
1. Let the robot vacuum cleaner run until the battery is low and it can no longer clean. Turn
the self-emptying base off to prevent the robot to return to it.
2. Hold down the power button to turn the robot vacuum cleaner off.
3. Remove the mixed tank from the robot vacuum cleaner and turn it upside down.
4. Remove the side brush and remove the screws from the cover on the body.
5. Remove the cover from the body. Fig. 31
6. Unplug the battery connector and remove the battery.
ENGLISH
,
2
69
CONGA 14090 TWICE ROLLER HOME&FILL
Advertenties
Inhoudsopgave
Probleemoplossen
