Inhoudsopgave
Advertenties
- Do not breathe the gas contained into the cylinder. It is forbidden to alter and/or modify the cylinder and valve
integrity.
- Remove the carbonating bottle if it is �lled with water before installing the cylinder.
- It is forbidden to remove and/or handle the cylinder while the soda maker is working.
- Always keep the cylinder away from any sources of heat and direct sunlight, keep in a cool and ventilated
place. It is forbidden to expose the cylinder to temperatures higher than 50°C.
- A high concentration can cause asphyxiation (EIGA-As). It contains gas under pressure; it may explode when
heated (H280). Liquid contact may cause freezing burns.
- Do not put the cylinder into the freezer and/or into the fridge. If frozen do not use it and keep it away from
the body.
- Do not use the content for babies' food preparation.
- Do not alter and/or modify the cylinder and the valve.
- Keep away from children.
- DO NOT attempt to puncture, throw or burn the cylinder.
- DO NOT transport the soda maker with the cylinder attached.
- The use duration of the cylinder depends on the use frequency.
3 General description
Product overview
A1
Refer to
Machine rating of information:
Maximum Working Pressure: 116 psi/ 8 bar
Maximum Allowed Operating Temperature: 40°C / 104°F
4 Before creating fun
Installing the gas cylinder
1. Place the Philips soda maker in an upright position and on a �at surface. Remove the carbonating bottle
before installing or replacing the cylinder if it is �lled with water. Remove the drip tray grid and then
carefully lay the soda maker down on the side.
2. Remove seal and cap from the CO
bottom. Don't drop the cylinder into the hole. When you feel that it reaches the bottom, begin
screwing the cylinder clockwise until it is fastened. Don't screw too hard since this might break the
threads holding the gas cylinder in place.
3. When you need to replace the gas cylinder, lay the soda maker down on the side and unscrew it
counterclockwise and then carefully pull it out of the compartment.
cylinder. Carefully insert the cylinder through the hole at the
2
A2-1
EN 2
A2-2
Advertenties
Inhoudsopgave
