Inhoudsopgave
Advertenties
To reduce some noises:
First, make sure your cellar is on a level surface.
Location is important, do not lean the cellar against the wall.
The bottles must be correctly loaded to avoid parasitic vibrations.
The noise may come from the circulation fan, check that nothing is interfering with its operation.
INSTALLATION INSTRUCTIONS
Before putting your appliance into service
Remove all inner and outer packaging components.
●
This appliance is designed to be free standing.
●
Before connecting your device to a power supply, allow it to stand upright for about 2 hours.
●
This reduces the risk of malfunction of the refrigeration system due to handling during
transport.
Clean the inner surfaces of the unit with a soft cloth and warm water.
●
Leave 10cm of free space between the back and sides of the unit to allow for ventilation of
●
the cooling system. Failure to do so will result in poor cooling performance, dust build up on
the components and dramatically shorten the life of the product. It may also void the
warranty.
Below are the guidelines for creating proper ventilation
Ventilation basics: While the unit is cooling(removing the heat)from its interior, the removed
heat is being dissipated through the condenser coil at the rear of appliance. This heat must
be removed with proper air circulation and exhausted to the outside of the cabinet enclosure.
If this is not done, excessive heat will build up inside the cabinet enclosure and prevent the
unit from maintaining proper cooling, increase power consumption and overheat the
electrical components.
Place your unit on a floor strong enough to support the weight of the fully filled unit.
●
Make sure the unit is level by adjusting the front feet underneath the unit. Make sure that the
●
appliance rests on its feet in a stable manner.
Install the appliance away from direct sunlight and heat sources (radiator, hot plate, etc.).
●
Direct sunlight can damage the unit's coating and heat can increase its power consumption. If
the ambient temperature is extremely cold or hot, this may prevent the unit from operating
properly.
The unit is not designed to be installed in a basement or cellar.
●
This unit is designed exclusively for indoor use.
●
Caution: Make sure that the unit is kept away from any substance that may cause combustion.
● Check that the water tank is in place before connecting the unit.
10
Advertenties
Inhoudsopgave
