Inhoudsopgave
Advertenties
CLEANING
GRILL REMOVAL
Screwdriver required for 530 only.
WARNING: To reduce the risk of electrical shock and injury to persons, power off and unplug the circulator before removing grill.
530
1. Remove the screw (only
Screw
necessary on model 530).
(530 only)
2. Depress one of the grill clips (A)
by placing your thumb against
the outside surface of the clip
and pressing downward towards
the motor, applying slight
pressure forward. Usually by
releasing one clip, the grill can
be removed. If the grill cannot
be removed, repeat the process
on remaining clips.
630
A flathead screwdriver can
(Screwdriver
also be used if the clips are
recommended)
difficult to release.
3. Replace by lining up the
clips with the holes and firmly
snapping the grill back into
place. Replace the screw (model
530 only).
10 English
A
A
CLEANING
BLADE REMOVAL
WARNING: To reduce the risk of electrical shock and injury to persons, power off and unplug the circulator before removing grill.
1. Pull the blade straight out from the shaft.
2. Wipe the Blade with a damp cloth. If your circulator
is used in a greasy environment, such as a kitchen,
mild soap or a common household cleaner may be
necessary. Do not use solvents. Do not place blade in the
dishwasher. The excessive heat can distort the plastic.
3. To reattach - be certain the flat side of the shaft aligns
directly with the corresponding flat side on the blade's
socket. Push the blade all the way on the shaft until it
bottoms out. Do not use a hammer as this could result
in bearing damage.
Note: The motor is
permanently lubricated
and requires no oiling.
11
English
Advertenties
Hoofdstukken
Inhoudsopgave
