Inhoudsopgave
Advertenties
Truck Mounted Charging System
Cleaning
After each use, clean all external surfaces (case, base, visor,
lens, window and straps) by wiping with a solution of mild
detergent and warm water.
Dry with a soft, lint-free cloth, to avoid scratching the optical
surfaces.
Periodically check connector terminals, video socket, ON/
OFF switch, locking latch and hinge for contamination. Clean
with a soft, lint-free cloth.
Warning! Do not use solvents or paint thinners to clean the
Thermal Imager; otherwise, the protective case may
become degraded.
Do not remove the thermal imaging camera cover or casing
as the system operates on high voltage. Only authorised
personnel may service the unit.
16
All manuals and user guides at all-guides.com
Troubleshooting the Truck-Mounted
Charging System
Troubleshooting Guidelines
Symptom
No LEDs lit
Power LED status is No batteries installed in the camera.
green and camera
battery LED does
not light when
camera is placed in
charger
Power LED status is Inspect battery contacts for dirt,
green and external
battery LED does
not light when
battery is placed in
charger
Batteries do not
fully charge
Warning! It is possible that charge can be terminated
abnormally. While this condition is rare, it can occur because
of external in-band noise that may reach the charger
electronics. In the unlikely event that charge is falsely
terminated because of noise, the battery may not fully
charge. Always use the camera battery gauge as an
indicator of battery condition.
Problem / Solution
Check power connections.
Is power available?
Is the positive power lead connected
to the positive terminal?
External in-line fuse blown?
Replace fuse.
Internal fuse blown?Replace fuse.
Verify that there are good batteries
in the camera.
Bad connection to the camera. Make
sure charger contacts are clean and
unbent. A small amount of contact
cleaner such as WD-40 can be used
to clean charger and camera charging
contacts. Reseat firmly to ensure
connection.
corrosion or damage. Clean contacts
or replace battery. Inspect the
contacts of the battery charger.
Verify they are clean, unbent, and
move down and spring back.
Out of operating temperature range.
Check that temperature of
environment and/or batteries is within
recommended operating range.
Power source is noisy. Ensure power
hook-up cable is connected to a
clean source without excessive
voltage spikes.
GB
GB
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
