Inhoudsopgave
Advertenties
EN
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool.
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild detergent
on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes
(where applicable)
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Troubleshooting
Problem
No function when ON/OFF
Switch (5) is operated
Slow material removal
Scratches on workpiece after
sanding
Burn marks on workpiece
Sanding Sleeve slides off the
Sanding Sleeve Drum (18)
10
Possible cause
No power
Defective ON/OFF Switch
Sanding sleeve or Flap Wheel grit too fine or worn
Variable Speed Dial (4) set at too low speed
Grit too coarse
Sanding Sleeve (19) or Detail Flap Wheel (20)
incompatible with material
Too much pressure exerted
Variable Speed Dial set at too high a speed
Sanding Sleeve incorrect size or faulty
Oil or grease or other lubricant on surface of Sanding
Sleeve Drum
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
UK Address:
Toolstream Ltd
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
De Keten
00004
5651 GJ
Eindhoven, Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the reach of children.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Check power supply
Have the ON/OFF Switch replaced by an authorised Silverline service centre
Fit new Sanding Sleeve or Flap Wheel with coarser grit
Increase speed
Fit new Sanding Sleeve or Flap Wheel with finer grit and continue sanding
of surface to remove scratches
Fit correct Sanding Sleeve or Flap Wheel
Use less pressure whilst sanding
Decrease speed
Replace with the correct size Sanding Sleeve
Completely clean and dry the Sanding Sleeve Drum
Solution
Advertenties
Inhoudsopgave
