Inhoudsopgave
Advertenties
IMPORTANT SAFETY INSTRUCTIONS
PURO/PURISSIMO adv is a complete filtering system
for freshwater ornamental outdoor ponds. Any other
use is prohibited and, consequently, not covered by the
manufacturer's liability.
WARNING: the appliance is not a toy.
WARNING: It is not suitable for use by children or unskilled
persons left unsupervised.
SAVE THESE INSTRUCTIONS CAREFULLY!
INSTALLATION
PURO adv: Follow the instructions on pages 20-21-22-23.
PURISSIMO adv: Follow the instructions on pages 24-25-26-27.
(Refer to the components listed on page 32).
Place the filter close to the edge of the pond, making
sure to place it on a level surface and on an area that
is not subject to flooding or overflow or where it might
accidentally end up in the water. The components and
the tightening spanner (5) are inside the accessory bag
found inside the filter. WARNING: to fit the water outlet
opening it is necessary to take out the basket containing
the bio-balls. Then insert the outlet opening (14) fastening
it with the relative sealing ring and nut (fig 7 and 11).
PURO adv: Install the sealing ring (6) on the hose
connector (13) and screw it to the valve (20). Fasten
the latter to the filter inlet using the proper sealing ring
(6) and lock it joining the sleeve(19) to the deflector
(18). In order to operate, the PURO filters must be
connected to a pump not supplied (fig.1-2 on page
20). The valve provided with the filter must be used to
adjust water flow in the filter inlet. For best performance
it is recommended to adjust the flow until you reach
the level indicated on the "WATER LEVEL" label (fig.5).
PURISSIMO adv: Install the support hook (12) of
the UV-C filter on the edge of the basin. Fit the UV-C
filter inserting the inlet in the intake position on the open
part of the support hook and afterwards turn it 90° until
the outlet of the UV-C filter can be inserted with the proper
sealing ring (6) in the hole of the filter basin. Fasten
everything with the sleeve (19) and the deflector (18).
PRS adv 1: screw the hose connector complete with nut
and sealing ring to the UV-C filter's inlet.
PRS adv 2/3: screw the hose connector complete with nut
and sealing ring to the valve . Fasten the latter to the UV-C
filter's inlet (fig.7) using the proper sealing ring (6).
Connect the pump to the UV-C filter's inlet through the
spiral tube provided in the box. The UV-C filter must
not be immersed in water. For more information on
the installation of the pump and UV-C filter consult the
relative instruction booklets . The valve must be used to
adjust water flow in the filter's inlet in case you are using
a pump with higher performances than the one supplied
English
in the box.
PRS adv 2/3: for best performance it is recommended
to adjust flow until you reach the level indicated on
the "WATER LEVEL" label (fig.5).
MAINTENANCE
In order to maintain optimal filtration it is recommended
to periodically inspect the clogging status of the filtering
media. Release the hooks and remove the covers. If the
water level of the first basin reaches the OVER FLOW
four holes (see page 23 and 24), it is recommended to
proceed with the filter maintenance . Disconnect the pump
and wait until the filter is completely empty. Remove the
baskets and wash the filtering materials with running
water. To take out the drum next to the water inlet it is
necessary to unscrew first the sleeve with the deflector.
Do not use chemical detergents. Before reassembling the
baskets, make sure to have completely removed the dirt
present on the basins bottom. Reassemble the baskets
in the filter paying attention that the numbers present on
the basin correspond to those indicated on the baskets.
These will be correctly placed only if the basket lame will be
inserted in the corresponding track of the basin up to the
coupling (fig.8). Close the covers paying attention to the
joining hooks (fig.9).
PUMP AND UV-C FILTER MAINTENANCE
For PURISSIMO models only: following the instructions
provided in the relevant instruction booklets for
maintenance.
TROUBLESHOOTING
If little water comes out of the filter:
• Check that the pump's suction is clean and obstacle-free.
• Check that any tubes connected do not have narrow
passages.
• Check that the filter materials are not excessively
clogged.
GUARANTEE CONDITIONS
This appliance is guaranteed from defects in its materials
and workmanship for a period of 3 years from the date
of purchase. If the appliance should not work correctly as
from the purchase date, return it to your local retailer. The
appliance will be replaced without any additional charge.
To use the guarantee service, return the appliance
and attach the proof of purchase and a detailed reason
for the claim. The appliance must be carefully packed
and protected from any damage during transport. The
guarantee does not cover damage due to impact or
being dropped after purchase. The guarantee is not valid
if the product is used incorrectly or if damage is caused
by tampering or negligence by the purchaser causing
the loss of fish or other animals, personal damage, loss
of properties or other damage that might arise. The
guarantee is not valid for components subject to wear
and tear (see * page 32).
Advertenties
Inhoudsopgave
