Inhoudsopgave
Advertenties
Check the direction of the motor in the log splitter with
threephase motor (400 V 3~), because operation in the wrong
direction damages the oil pump.
At temperatures below –5° C, let the log splitter run for at
least 15 min. in neutral to heat up the oil.
2. Place the log on the log splitter table.
Place the log to be split vertically on the table.
Make sure that the log stands vertically on the table.
Never try to split the log horizontally.
Only split the logs in the direction of the wood fibres.
The machine can be damaged if you try to split wood across
the grain.
3. Hold
the
log
tight
For a safe and stable splitting, the log must be centered
between the clamping jaws.
Make sure that the clamping jaws are adjusted according
to the log diameter. For small diameters, they have to be
adjusted inwards.
4. Press both operating handles down simultaneously:
The splitting blade falls down and splits the log.
5. Release the two control handles, the splitting blade returns to
its initial position.
If you only release one control handle, then the splitting
blade remains where it is.
Special instructions for splitting logs:
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be increased by
shortening the return of the splitting cutter.
1. Place the log on the
splitting table and press
the two control handles to
bring the splitting blade
down to approx. 2 cm
above the log.
2. Release one control handle so that the blade stays in this
position.
with
the
clamping
claws.
3. Switch the machine off and disconnect the power.
4. Release the second control handle.
5. Shorten the return
path at the rod
fitted to the side by
fixing the holding
screw
at
the
necessary height.
Adjusting the table height
Upper table plate position: 590 mm.
Middle table position: 900 mm.
Lower base position: 1325 cm.
1. Split logs up to 590 mm on the table plate.
Secure the table plate using the locking bolt.
(The locking bolt engages in the table plate hole.)
2. Split logs up to 900 mm on the table. Pull out the table
plate.
3. Split logs up to 1300 mm on the base. Press the locking lever
down and swing aside the table.
Holding screw
27
Advertenties
Hoofdstukken
Inhoudsopgave
