Inhoudsopgave
Advertenties
PNEUMATIC CONNECTIONS
Connect hose coiler to compressed air system at a maximum pressure not exceeding 300 psi. Mount a quick
fi tting or the pneumatic tool on the pipe as it comes out, using the fitting already pressed onto the pipe. While
in use, prevent the pipe from rubbing on sharp edges or on blunt objects. If the pipe is deteriorated, have a
specialist replace it. The coiler is equipped with a spring-loaded coiling system with automatic blocking device.
Always guide the pipe while it is being coiled and take care, while operating, not to accidentally release the
catch. Install the coiler in such a way as to prevent it from causing injury to personnel or damage to property.
If this coiler is destined to be installed on a machine, it is expressly forbidden to start operating it before the
machine where the coiler is installed has been declared to be in compliance with the directive's norms.
GENERAL PRECAUTIONS
Components have been chosen and used keeping mind the operatingconditions and life span of the machine.
Install the machine so that it presents no danger to exposed personnel, as long as it is used correctly. No
protection or warning will ever be sufficient if the person fails to take certain precautions, if the machine is not
maintained in peak operating condition, and if the following recommendations are not followed. Learn correct
use and adjustment before starting work. Check that personnel using the machine does so safely and knows
its operation. Avoid exposing yourselves and others to unnecessary risks. Insist that personal protection
systems be used, where prescribed. Do not remove, modify, or inhibit SAFETY DEVICES put in place by the
manufacturer, but rather verify that they are not removed or rendered less effective. Work in an environment
that is orderly and free of hazards, with adequate light and room to work in. Keep the working area free of
tools and any other unnecessary object.
Never exceed the max working pressure
Do not open the spring cover
Hold the hose while rewinding
Not
suitable
transmission or liquids
WARRANTY:
- 12 months from the purchase date.
- The 12-month guarantee is referred to any defect of the new material included in our supply and properly
used; any part subject to wear or damaged by the user (cables, springs, pipes, manifolds, etc.) will therefore
be excluded.
- Any other type of compensation is expressly excluded.
- The warranty consists of free repair or replacement of the parts that, in our final judgment, are materially or
operationally defective.
- Replacement or repair of parts subject to operating wear is excluded.
- Transportation expenses are at buyer's charge.
- The warranty is not applicable when the device is damaged due to misuse.
Malfunction
The hose does not retract completely.
The hose cannot be locked in the
unrolled position.
for
inflammable
gas
ANY PROBLEMS
Cause
The hose could be dirty.
The hose is not unlatched.
The hose reel cannot swivel on its
bracket.
The wind-up spring could be broken.
The latching lever could be broken.
In the event of having to do work
on the mechanical parts or replace
the
tube,
contact an after-sales
centre. Work done by unauthorised
persons is very risky due mainly to
the
preloaded
spring
invalidate every type of warranty.
Corrective Action
Wipe the hose off with a clean cloth and some
water or other non-solvent liquid.
Pull out the hose and let it retract back to the
hose reel.
Check the wall/ceiling installation and make
sure there is sufficient space for the reel to
move.
Have it checked by a after-sales service agent.
Have it checked by a after-sales service agent.
and
will
Advertenties
Inhoudsopgave
